Heater Non-Purge Adsorption Air Dryer PHNP Series

When purge air is not available, the unit heats with electric heater only, increasing power cost but no purge air consumption.If the heat on the compressor side is not available, such as a oil injection air compressor, it can only be heated with an electric heater, which increases the electric power cost but does not consume any purge air.Design FeaturesApplicable regardless of compressor typeApplicable regardless of compressor typeNo purge air consumption, low noise operationNone purge air consumption at all. Operating low noiseGas moisture removal and suitable for chemical plantSuitable for removing moisture from gas and chemical plantDESIGN CONDITIONDesign Pressure : 9.7 bar (Standard)Max. Air Inlet Temperature : 40℃Operating Cycle : 8.0 HrsDewpoint : -40℃ (std.)